1. Maintenance method of medical centrifuge:
1. Use water or mild detergent to clean the rotor chamber and rotor. Alkaline solutions or solvents that are abrasive to the material should not be used.
2. Open the top cover when the centrifuge is not in use and keep the rotor chamber dry to avoid wear on the motor bearings.
3. Use a rag or tweezers to remove the debris from the rotor chamber.
4. Special safety protection measures must be taken when centrifuging toxic, radioactive and contaminated samples.
2. Maintenance method of medical centrifuge accessories:
1. The centrifuge should try to keep a certain distance from other electrical equipment, and have good grounding measures, and conduct regular inspections.
2. The centrifuge and rotor must not be exposed to high-intensity UV radiation or heated for a long time. Use neutral detergent when cleaning.
3. If necessary, the rotor can be replaced. After reinstalling, tighten the head screw.
4. If the centrifuge tube shows color change, deformation, leakage, etc., it must be stopped.
5. Do not screw on the cap when performing high temperature and high pressure sterilization of the centrifuge tube to avoid deformation of the tube. See the list in this section of the user manual for the temperature resistance of each centrifuge tube.
3. Maintenance method of medical centrifuge condenser:
1. The condenser is used to cool the refrigerant. It is installed at the rear of the centrifuge and uses air cooling.
2. The condenser should be regularly cleaned of dust to avoid hindered heat transfer. This can be purged with compressed air.
4. The maintenance method of the rotor pin of the medical centrifuge: the rotor pin needs to be lubricated frequently with lubricating oil to ensure the smooth operation of the centrifuge.
5. Sterilization and sterilization methods of rotor chamber and accessories of medical centrifuge: all conventional disinfectants can be used. Since centrifuges and accessories are made of different materials, the compatibility of disinfectants must be considered.
6. The medical centrifuge operator should ensure that the important parts of the centrifuge are intact, mainly including: stable motor suspension, no corrosion of the rotor and accessories, no deviation of the rotating shaft, screw connection and good grounding
Traffic guardrail is a kind of traffic safety facility set on the outside of shoulder, traffic separation zone and sidewalk kerb. The collision energy is absorbed by self-deformation or vehicle climbing, so as to change the driving direction of the vehicle, prevent the vehicle from going out of the road or entering the opposite lane, and minimize the injury to the occupants.
Road Traffic Barrier,Traffic Noise Reduction Fences,Road Noise Reduction Fence,Traffic Control Barriers
Anping County chengchuang Traffic Wire Mesh Manufacture Co., Ltd , https://www.xhmetalfence.com