The platesetter is a typical prepress device and is one of the printing devices. It is divided into a variety of different technology platesetters according to different types/models, such as photosensitive imaging technology, thermal imaging technology and so on. Understand what is a plate making machine? Let me talk about the operation methods of the platesetter.

1. Place the machine in a dust-free, dry, constant temperature, leveling environment, fix the front casters, and open the cover.

2, adjust the brush, fill the water or fresh solvent into the water tank, gently brush the brush by hand, so that the brush is evenly wet, then cover the lid, stop for 1 second, open the lid, check the water stain on the glass of the flat plate trace;

3, back exposure, first set the exposure time, open the exposure drawer, cut the flexible version, put the back side up on the exposure pumping, the center of the suction plate in the drawer, gently push the exposure drawer, set the exposure Time, press the exposure switch key, the exposure starts. 4. Pull open the exposure drawer, roll up the vacuum film, and expose the flexible version of the back, and tear the upper layer protection one at a time. The layer is placed face up in the center of the suction plate in the exposure drawer.

5. Place the film of the film face down on the plate. The area of ​​the plate must be slightly larger than the area of ​​the film. Use a 1~2cm wide gas guide to cover the place where the plate and the film are in contact. The gas guide can be used for washing the water. The material of the lint does not allow the gas guide to cover the part of the film that has content!

6. When the time is up, the digital tube number stops beating, returning from 000.0 to the exposure time you set, and there is a “嘀” prompt to end the exposure.

7. Press the vacuum switch key, the vacuum pump stops working, open the exposure drawer, roll the vacuum film, remove the exposed flexible plate, paste the double-sided tape on the back, then remove the film and put it on, open the cover of the machine. Flat paste on the glass of the flat plate.

Article source address: http://

Silicone Holder Keeper

Silicone Replacement Watch Strap Band Keeper Loop Security Holder replacement watch band strap loop Watch band loop is made of silicone , a soft silicone like rubber.rubber watch band loop replacement keepers it is flexible, sturdy and easy to get on the wristband.

Our main business is customization Silicone Phone Case,Silicone Rubber Sealing Ring Gaskets Grommets Accessories, Silicone Bracelets, Silicone Watchband, Silicone Keychains, Silicone Kitchenware. Silicone Spoon ,Silicone Stopper, Silicone Placemat Silicone Scrubber,Silicone Baby Products, Silicone Backpack ,Silicone Pet Supplies If you are interested, please consult

Silicone Holder Keeper,Silicone Watch Strap Loop,Rubber Retainer Holder Keeper

Shenzhen Yindingsheng Technology Co., Ltd , https://www.ydsoemsilicone.com